Can monitor up to 6 regular tanks and 2 LP tanks that already have 90 ohm sending units in them or other resistive sensors like the WEMA fuel float sensors. If your resistive sensor has opposite calibration settings (ie 0-240 ohm where 0 is Full and 240 is Empty) then 

The MODA sensor module is a non-invasive exterior tank level sensor. This sensor is attached to the outside of a plastic or fiberglass tank eliminating the possibility of sensor malfunction due to fouling by tank contents.

In cases where there is no access to the sides of a plastic water or waste tank to apply the aluminum tape required by the MODA sensor modules, or in the event that the tank to be monitored is constructed of metal, a PVC rod-style sensor can be used.

This sensor was developed to incorporate Diesel Tank monitoring with any of our existing tank monitoring systems. This unit installs into a SAE standard 5 hole fuel sender opening in the fuel tank. A BUNA-N gasket and 5 stainless steel screws are included with the sensor. These sensors are custom made to the length specified by the customer at time of order (from 6" to 70"), and the unit is factory calibrated. The sensor head is 2.75" by 0.75" in size and requires about an inch of clearance (measured from the top of the tank) to install.

We do not sell resistive sensors but if you have resistive sensors that you would like to add to the iSeries system, you can add up to 2 per panel. (ie. WEMA sensors, etc.) These resistive sensors can be installed onto tanks 7 & 8 only. Sensors that have the Low ohm setting for Empty and High Ohm setting for full can use the standard calibration directions in the manual. (ie. 0-240 where 0 is Empty and 240 is full)

2 Copper sticky squares with 6" wires already soldered to them to splice to your current moda sensor wires and 2 Butt Connectors.